Search by characteristic or function/KOA Products

HOME>Products TOP>Search by characteristic or function

Search by characteristic or function

Resistors(SMD)

Resistors(Leaded)

Resistors(Network)

Trimmer Potentiometers

Varistors,Surge Absorbers

LTCC substrate

Hybrid IC

Others

Application Notes

Brush up your circuit

Basic Knowledge

Precautions for Use

Disclaimer

Site Map

Characteristic/Function

	General Resistors - SMD Type		General Resistors - Leaded Type
	General SMD type resistors.		General leaded type resistors.

	Power Type Resistors - SMD Type		Power Type Resistors - Lead configuration
	Chip resistors with rated power of over 1W.		Lead configuration resistors with rated power of over 0.25W.

	High Precision Resistors		Current Detecting Resistors/Low Resistance Resistors
	High precision resistors with resistance tolerance under 5%.		Low resistance resistors; suitable for current detecting in high- current circuit.

	Temperature Compensation / Thermal Sensing		Thermistors
	Temperature coefficient of resistance (TCR) is constant; resistance value changes to the temperature in linear.		Resistance of the thermistor element depends on temperature.

	Fuses/Fusing Resistors		High Resistance Resistors
	Normally it functions as a resister, but it acts as a fuse upon exposure excessive voltage.		Resistors series with resistance value of over 1M.

	Flame Retardant Coating Resistors		Resistor Networks
	Resistors with outside coating of flame retardant polymer.		Resistor networks with the combinations of R and R, or R and C.

	Resistors for High Voltage		Zero Ohm Resistors
	Resistors suitable for using it for a high-voltage circuit		Jumper chips and Jumper- lead for short circuit on the printed circuit board.

	Resistors with High Resistance to the Surge		Surge Absorbers
	Excellent characteristics for resistance to the pulse and high reliability.		Discharge tube type surge absorber element utilizing micro-gap.

	Non Trimmed Resistors		Trimmer Potentiometers
	Resistors without trimming to cut out a slit from resistors-body for adjusting resistance value .		Resistors which can change resistance

	Damping Resistors		Termination Resistors /"Pull-up / Pull-down"
	Suitable for "Damping Resistors"; inset resistors in series to remove noise(EMI).		Adjusting impedance in line (Termination), Stabilization of line-current.